RADIO COMMUNICATIONS - WEB SERVER - IoT SYSTEMS - WIRELESS SYSTEMS
ADDITIONAL SECURITY
TELECONTROL MODULES - MY ALARM
01
MODELO MY 2B
GSM / GPRS telecontrol unit for industrial and domestic uses. Activation of signals through SMS commands.
Notices by SMS or e-mails.
It works like a mobile phone in terms of communication.
02
MODELO MY 2S
GSM / GPRS autonomous communicator.
Use as an additional intrusion or fault alarm.
Sending SMS or pre-recorded voice messages (requires SIM).
Battery status autotest
03
MODULO B-ALARM
Basic unit of 1 digital input and 1 output. ideal for domestic control, process plants or machinery.
Equipped with GSM.
04
CONFIGURATION VIA SOFTWARE
My Alarm: Depending on the model, we have up to 4 digital inputs, 2 analog inputs and 2 relay outputs.
Z-LINK1-LO RADIOMODEM 868 MHz LoRa
Link equipment without increasing costs by installation or wiring.
Configuration of the equipment by switches or software.
DSSS modulation.
Transmission power 40 mW.
Physical layer with LoRa technology.
High immunity to radio interference.
Modbus RTU protocol.
Maximum reach: 1 Km.
Status LEDs (power, error and Tx).
Z-AIR RADIOMODEM 868 MHz s/2014/53/UE (RED)
Radio Modem 868 MHz with RS 485. Electronics encapsulated inside the antenna itself.
IP65 for outdoor mounting.
It does not require a license to use according to the ERC70-3 standard.
As a result of the integrated assembly, there is no additional loss of signal.
It is a very flexible equipment for a wide variety of applications.
It is powered at 24 Vdc.
Scope, up to 7 km in open field (according to conditions of the orography and installation of the antenna).
Speed 9600 bps (@ 25 KHz), 19200 bps (@ 50KHz).
SENSINEXT RADIO EQUIPMENT
Radio communication system for Pt-100 inputs and 4-20 mA signals.
The transmitters are totally autonomous, they only require power with batteries.
It is an ideal system for applications where installation is not required.
CPU with RS485 Modbus RTU communication. In option with TCP / IP.
The PC is connected from the CPU and the data is displayed. The software allows the registration, continuous visualization and the treatment of the information.
Supervise remotely by accessing via web.
REMOTE CONSULTATION OF YOUR APPLICATIONS
At any time you can be consulting the status of your installation via web
Access your SCADA system or your HMI screens from any remote point that has internet.
PROCESS SUPERVISION - HMI
Supervision on tablet
Total connectivity
In option with Mac
Functionality:
- Wire-less access
- Modbus Gateway
- Remote access
- OPC UA Optional
CMT MODULES FOR LINKING TO TABLETS
SEE THE STATE OF YOUR PROCESS VIA WEB SERVER
While you are away from your work center, you can consult remotely and continuously the status of your installation using web server technology.
Computers that autonomously store the data of your line and send it to the cloud so that you can consult it at all times.